Brief Introduction Of Bushing

Apr 19, 2021

Leave a message

In the moving parts, the wear of the parts is caused by long-term friction. When the gap between the shaft and the hole is worn to a certain degree, the parts must be replaced. Therefore, the designer chooses lower hardness and better wear resistance when designing. 

The material is the shaft sleeve or bushing, which can reduce the wear of the shaft and the seat. When the shaft sleeve or the bush is worn to a certain degree, replace it, which can save the cost of replacing the shaft or the seat. Generally speaking, the bush and the seat are used Interference fit, and the use of clearance fit with the shaft, because no matter how it is still unavoidable, it can only extend the life, and the shaft parts are relatively easy to process; there are also some new designers who do not like this design, think it is It is to increase the cost during manufacturing, but after a period of use, it is still necessary to modify this method when repairing, but the modification will easily cause the accuracy of the equipment to decrease. The reason is simple. The secondary processing cannot guarantee the position of the center of the seat hole. To add, the sleeve is used to replace rolling bearings in some places with low speed, high radial load and high clearance requirements (such as camshafts) (in fact, the sleeve is also a kind of sliding bearing), and the material requires low hardness and resistance. For grinding, the inner hole of the shaft sleeve can be ground and scraped to achieve high matching accuracy. There must be a lubricating oil groove on the inner wall. The lubrication of the shaft sleeve is very important. If dry grinding, the shaft and sleeve will soon be scrapped. Recommended here When installing, scrape the inner hole wall of the shaft sleeve, so that many small pits can be left. The enhanced lubrication bushing and the shaft sleeve are selected according to different industrial and mining conditions. The most important conditions are: pressure, speed, pressure-speed product, lubrication status, and load properties. The quick, easy and excellent automatic selection of bushings is included. 



Send Inquiry
you dream it, we design it
Quanzhou Xinlida Machinery Manufactory Co., Ltd
contact us